bearing for mining conveyor the installation is correct, affecting the accuracy, life, performance. Therefore, the design and assembly department for bearing for mining conveyor of the installation should be fully studied. Want to be installed in accordance with the work standards. Operating standards are usually as follows:
1 cleaning bearing and bearing connected components
2 check the size of connected components and finish machining.
3 installation
4 installed after the inspection of the bearing
5 supply lubricant
Hope that in the upcoming installation, just open bearing for mining conveyor packaging. General grease lubrication, non cleaning, direct filling grease. Lubricating oil lubrication, the general does not have to clean, but the instrument or high-speed bearings, etc., to use clean oil, remove the rust on the bearing. Remove rust agent bearing, easy to rust, so you can not put aside. Furthermore, have grease sealed bearings, not directly use cleaning.
Bearing installation method, due to bearing structure, coordination, conditions vary, in general, due to the multi axis rotation, so the inner ring needs to be too tight fit. Cylindrical bore bearing, press in with the press, or with hot charging method. Tapered bore, directly installed in the taper shaft, or sleeve installation.
Mounted to the casing, general clearance, the outer ring over the amount of interference, usually by a press indentation, or cooling after installation methods of shrink fit. Using dry ice as a cooling agent, shrink fit occasion, the moisture in the air condenses on the bearing surface. Therefore, the need for appropriate anti rust measures.
Contact Us
Shandong Xinkaite bearing Co.,Ltd.
Unified Social Credit Code:9137 1525MA3C 5428XP
Address:Xu Village Industrial Garden,Gan Town,Guan County,Shandong
Phone:086+0635-5638235 Fax:086+0635-5638808
Mobile Phone:086+15563545668
Email:xkte@xinkaite.com