 |
bearing for mining |
10,22,2016 |
|
bearing in mining |
10,22,2016 |
|
bearing of mining |
10,22,2016 |
|
mining bearing |
10,22,2016 |
|
mining bearing |
10,22,2016 |
|
mining bearing |
10,22,2016 |
|
bearing for mining drum |
10,21,2016 |
|
bearing for mining drum |
10,21,2016 |
|
bearing for mining drum pulley |
10,21,2016 |
|
bearing for mining pulley |
10,21,2016 |
|
| Current Location：Home
- News |
6205 bearing maintenance needs to know the basics
|
| Time：2016.07.04 News Sources：Shandong Xinkaite bearing Co.,Ltd. Views：
|
First, insist on clean and smooth bearings 6025
6025 bearings on the front view, should lead to the appearance of 6025 bearing cleaning, and then open the bearing surrounding parts. Here must pay attention to it, it is very weak seal parts, so when viewing and 6025 bearing disassembly Do not use excessive force to prevent damage to the formation of parts. If when viewing the bearing seal and the surrounding parts have shown poor performance, please replace must prevent the formation of poor seal will then cause bearing damage.
Second, the quality of 6025 bearing smooth agent.
Many find that late life is too short bearing number, in addition to other elements normally found outside, I do not know the quality of such smoothing agents also directly affect. Glazes bearing on the way to view: Glazes stained little conflict between two fingers, if contaminants, is feeling out; or coated with a thin layer on the back of the hand smoothing agents, then sealed light viewing. Then that is a replacement bearing smoothing agents.
Note: Before using the best first oil by filtration. The use of grease smooth bearing when replacing the grease, the use of in addition to Joe should prevent any part of the cotton material then angle to the bearing. Because these residual fibers can be wedged in between the rolling elements and the formation of damage, especially small bearings use more should pay attention to this question.
Third, bearing the operating environment.
When viewing the bearing, do not leave it exposed to environmental pollutants or moisture. If the job is aborted when, should be oiled paper or plastic film covering similar information has been machine. Bearing operating environment is also very important, where many mechanical bearings that is due to the operating environment is not available, resulting in the number of imported bearings life ended prematurely. |
|
|
