 |
bearing for mining |
10,22,2016 |
|
bearing in mining |
10,22,2016 |
|
bearing of mining |
10,22,2016 |
|
mining bearing |
10,22,2016 |
|
mining bearing |
10,22,2016 |
|
mining bearing |
10,22,2016 |
|
bearing for mining drum |
10,21,2016 |
|
bearing for mining drum |
10,21,2016 |
|
bearing for mining drum pulley |
10,21,2016 |
|
bearing for mining pulley |
10,21,2016 |
|
| Current Location：Home
- News |
Bearing maintenance and maintenance of important links
|
| Time：2016.11.19 News Sources：Shandong Xinkaite bearing Co.,Ltd. Views：
|
1. The bearing oil bath is smooth
Smooth oil bath is the most common bearing smooth way, suitable for low and medium speed bearings smooth. A part of the bearing is immersed in the groove, the smooth oil from the rotating bearing parts with, and then back to the oil tank should be slightly lower than the minimum rolling center.
2. The bearing dripping oil is smooth
Dropping smooth Suitable for the need to quantify the supply of lubricating oil bearing parts, drop oil every 3-8 seconds a drop is appropriate, too much oil will cause the bearing temperature increased.
3. Bearing circulation oil smooth
With the oil pump will filter the oil to the bearing parts, through the bearing after the smooth oil and then filtered to use. Because the cycle of oil can take away certain heat, so that bearing cooling, so the law is applicable to high-speed bearing components.
4. Spray the bearing smooth
With the dry air through the contraction of the sprayer and oil mixed caused by oil mist, radial bearings, the air flow can effectively cool the bearing and to avoid impurities intrusion. This method is suitable for high-speed, low-temperature bearing parts smooth.
5. Radiation of bearing is smooth
Oil pump will be low pressure oil shot through the nozzle in the bearing, the oil into the bearing through the other end of the oil into the oil tank. In the bearing high-speed rotation, the rolling element and the cage is also a high rotational speed to the surrounding air caused by air, with individual smooth way is difficult to smooth oil sent to the bearing, then must use low-pressure radiation will be smooth oil spray To the bearing, the nozzle position should be placed between the inner ring and the center of the holder.
|
|
|
