 |
bearing for mining |
10,22,2016 |
|
bearing in mining |
10,22,2016 |
|
bearing of mining |
10,22,2016 |
|
mining bearing |
10,22,2016 |
|
mining bearing |
10,22,2016 |
|
mining bearing |
10,22,2016 |
|
bearing for mining drum |
10,21,2016 |
|
bearing for mining drum |
10,21,2016 |
|
bearing for mining drum pulley |
10,21,2016 |
|
bearing for mining pulley |
10,21,2016 |
|
| Current Location：Home
- News |
Bearing thrust bearing installation
|
| Time：2016.10.29 News Sources：Shandong Xinkaite bearing Co.,Ltd. Views：
|
Thrust bearings generally take the axis of the shaft and the axis for the transition with the seat ring and the bearing seat to take action, so this type of bearing easy to install.
This type of bearing installation to control the shaft raceway (or groove bottom) for the axis of the vertical axis, such as the vertical out of control, will bear the load side of the bearing prone to early failure, performance is also greatly affected by influences.
Such bearings are subject to unidirectional load, mostly installed in pairs, but the operation only bear one direction of the load, it is necessary to give a certain preload to prevent load bearing that one bearing clearance is too loose, rolling The body in the raceway slippery and severe wear and tear.
For the two-way thrust bearing bearing load that is not the same row of rolling elements, but also similar methods should be used to pre-tighten to prevent similar severe wear phenomenon.
|
|
|
