 |
bearing for mining |
10,22,2016 |
|
bearing in mining |
10,22,2016 |
|
bearing of mining |
10,22,2016 |
|
mining bearing |
10,22,2016 |
|
mining bearing |
10,22,2016 |
|
mining bearing |
10,22,2016 |
|
bearing for mining drum |
10,21,2016 |
|
bearing for mining drum |
10,21,2016 |
|
bearing for mining drum pulley |
10,21,2016 |
|
bearing for mining pulley |
10,21,2016 |
|
| Current Location：Home
- News |
0 class deep groove ball bearing its use must also be carried out accordingly
|
| Time：2016.10.24 News Sources：Shandong Xinkaite bearing Co.,Ltd. Views：
|
0 class deep groove ball bearings are precision components, its use must also be carefully carried out accordingly. No matter how high the performance of the bearing, if used improperly, you will not get the desired high performance. The use of bearing attention to the following four, the full prevention of bearing corrosion
Directly pick up the bearings by hand, to fully wash away the hands of sweat, and coated with high-quality mineral oil after the operation, especially in the rainy season and summer to pay attention to rust. However, under certain operating conditions, the bearing can be obtained longer than the traditional calculation of life, especially in the case of light loads. These special operating conditions are surface damage that can be caused when the rolling surfaces (rails and rolling elements) are effectively separated by a lubricating oil film and the contaminants are restricted. In fact, under ideal conditions, so-called permanent bearing life is possible.
0 class deep groove ball bearings are the most commonly used rolling bearings. Its structure is simple, easy to use. Mainly used to bear the radial load, but when increasing the bearing radial clearance, with a certain angular contact ball bearing performance, can withstand radial and axial joint load. In high speed and should not use thrust ball bearings, can also be used to bear the pure axial load
|
|
|
